November 7, 2009 at 8:18 pm
Symptom
When the “Import All’ option is selected for import from CTS system and if the CTS transport requests contains changelists with Integration Directory content, the import fails with the error message similar to that as below:-
class java.rmi.RemoteException: [...]
August 5, 2009 at 1:19 am
Symptom
You use “import all” or “import project” as the import strategy in the Transport Management System (TMS). In exceptional cases, you want to import all the requests again. To do this, you previously had to use tp at command line level (umode=1) because the “- Import all requests again” option was not [...]
July 30, 2009 at 7:21 am
Symptom
This note contains an overview of all transports and corrections necessary for a certain R/3 release. It is updated on a regular basis.
The following areas are affected:
Errors in the R/3 system (Data Dictionary, tp, R3trans, R3up, saposcol, CCMS, and so on)Missing functions (database monitor, and so on)Checks for Going-Live service
Other terms
DB2/390, DB2 390, DDIC, [...]
July 30, 2009 at 7:01 am
Symptom
During the import of data to SLD, the entire Common Information Model (CIM) namespace is locked by default (usually, sld/active). Therefore, you cannot enter any further data in the locked namespace during the import. This affects, for example, the registration of systems, for example, using transaction RZ70.
Other terms
System Landscape Directory, SLD, [...]
July 24, 2009 at 8:24 am
Symptom
Problems or errors occur during conversion from non-Unicode SAP System
to Unicode. This SAP Note applies for Single Code Page and MDMP system
conversion.
Other terms
MDMP, Single Code Page, database export, database conversion, database
import, R3load, SPUMG, SUMG, preconversion, postconversion
Reason and Prerequisites
You encounter problems or errors during system conversion.
Solution
Attached to this SAP Note you will find a Troubleshooting Guide, [...]
June 8, 2009 at 4:38 am
Symptom
You observe very long import runtimes in systems with a large db_cache_size. Runtime measurements show that:
- The import lasts approximately 6 hours when the db_cache_size is 2 GB.
- The import lasts approximately 10 hours when the db_cache_size is 5 GB.
- The import lasts approximately 30 hours when the db_cache_size is 20 GB.
You observed these [...]